Post by ASadlyDeficiantProgrammer on Oct 28, 2013 11:33:20 GMT -5
I want a program that interfaces with Redpower 2, version 1.4.7.
It needs to power different colored wires by being connected to a bundled cable.
This is going to be an elevator that only goes down, not up...
The basic design will have a water blocks on each floor, but you can fall through them normally. When you tell the computer you want floor 5, it will power a piston for a set number of seconds that will push a block under the water on floor 5.
It needs to power different colored wires by being connected to a bundled cable.
This is going to be an elevator that only goes down, not up...
The basic design will have a water blocks on each floor, but you can fall through them normally. When you tell the computer you want floor 5, it will power a piston for a set number of seconds that will push a block under the water on floor 5.